3,75 EURO / Film - Exp. date 03/2015
Low - sensitive B&W film with extremely fine grain and controllable contrast
Important handling notes for films with a synthetic film base:
The emulsion is coated onto a transparent synthetic base providing excellent long-term and dimensional stability.
This films has to be loaded in the camera and unloaded in subdued light. Before and after exposition always store the films in the black light-tight film-container. Not following these advices can cause light infiltration through the base material to the exposed pictures. Rollfilms: Please take care in handling the 120 size films in keeping the film-roll tight with two fingers after breaking the unexposed adhesive label to avoid that the film is rolling to "spring off". The same procedure should be followed after taking the roll film out of the camera. The exposed film should be kept compellingly again in the black light-tight rollfilm-container. |
Properties:
low sensitive, very highly solvent superpanchromatic film; very good resolving power, extremely fine grain, and very high sharpness; special coating for the improvement of the film transportation characteristics in the camera; polyester film layer with high anti-breaking and ultimative tensile strength; archive stable LE500 (live expectancy 500 years, examined by the Rochester Institute of Technology, Rochester, USA); No-curling coating for the improvement of the film flatness; Anti-Newton-coating against the development of Newton rings; the film can be used with daylight and electronic flash lights; the film behaves before and after the development anti-statical; spectrale sensitivity from 370 up to 700nm; accurate, tear-firm, P.E.T. film layer;
Technical data sheet,
film and developer, valid from May 2011: Download PDF
Techn. datasheet
valid to April 2011:
Download PDF
Techn. datasheet ATP-DC developer,
produced until April 2011:
Download PDF
Film layer structure:
glass clear P.E.T. layer: 100 micron
emulsion coating emulsion: layer with super coating
film back side: anti-static coating and anti-Newton coating
Resolving power: 300 Lp/mm at a contrast of 1,6:1,
corresponds to approx. 900 Lp/mm at 1,000:1
Emulsion layer thickness: 4 micron
Exposure index: ISO 32 / 16 DIN / daylight
Characteristics:
spectrale sensitivity from 370 up to 700 nm
Density curve: Processed in ROLLEI Low Contrast (RLC), 1+4, 6 minutes, with 20°C.
Tip intervas: first 30 sec. permanent, than all 30 sec. 5 times
Film storage:
It is recommended not to expose the film into direct sun light, strong heat or high air humidity.
unexposed film: idea are 13°C, with longer storage 8°C (refrigerator).
exposed film: after exposure process as soon as possible, keep cool as possible.
Film processing:
The ROLLEI ATP 1.1 is to be processed, because of its superpanchromatic characteristics, in complete darkness.
|
